LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 27 (Battery, Charging System And Starting System) >> Diagnostic Information and Procedures >> DTC C0800 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the distance sensing cruise control (DSCC) module.
  2. Ignition OFF, test for less than 5.0 ohms between the ground circuit terminal 6 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify a test lamp illuminates between the ignition 1 voltage circuit terminal 1 and ground.
    • If the test lamp did not illuminate, test the ignition 1 circuit for a short to ground or an open/high resistance.
  4. If the circuits test normal, test or replace the DSCC module.