LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Cruise Control System) >> Diagnostic Information and Procedures >> Cruise Control Malfunction (With K59) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the harness connector at the steering wheel controls switch - left.
  2. Cruise control switch ON, measure the resistance between terminal 1 and terminal 5 while individually activating and holding each cruise control function switch and compare the resistance reading to the values in the table below.
    • If not within the specified resistance range, replace the steering wheel controls switch - left.
Function Switch Minimum Resistance Value Maximum Resistance Value
Neutral O.L. O.L.
Cancel 1.9k Ohms 2.1k Ohms
Gap Up 3.5k Ohms 3.7k Ohms
Gap Down 6.6k Ohms 6.8k Ohms
scientia non olet · About LEMON Manuals