DSCC Module Inhibits

The distance sensing cruise control (DSCC) module inhibits the Adaptive Cruise Control (ACC) System when any of the following conditions exists:

• The RADAR NOT READY message is active in the driver information center (DIC).
• Initial brake pedal travel signal from brake pedal position (BPP) sensor is not present
• An ACC System malfunction and/or failure is present.
• The CLEAN RADAR indicator is active in the DIC.
• An invalid vehicle speed
• The Antilock Brake System (ABS) is active during automatic braking.
• The Cruise Switch failed message from the BCM is sent to the DSCC module.
• Automatic braking failure-a serial data message from the electronic brake control module (EBCM) the to DSCC module indicating an automatic braking failure
• The brakes overheated signal from ABS
• The ACC System audible warning is not present, due to an audio amplifier failure.
• The DSCC module transceiver temperature is hot.
• The ACC is not present-the ACC can be disabled through the BCM ACC disable feature.
• The driver applied brake pressure.