Cruise Engaged

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

The Adaptive Cruise Control (ACC) System will engage and adjust vehicle speeds based on the activation of the following cruise switches:

On/off
Set/decrease
Resume/increase

ACC will not engage if any inhibit criteria is active. Also, the driver must step on the brakes at each ignition cycle before attempting to engage ACC. The engine control module (ECM) looks to the body control module (BCM) for the brake initial travel achieved signal indicating that the driver has stepped on the brakes before attempting to engage ACC.

The vehicle speed must be at or above 48 km/h (30 mph) and below 188.3 km/h (117 mph) for the ACC System to be engaged. In the engaged state, the ACC System allows the driver to override the controlled vehicle speed temporarily while still remaining in the engaged state.