Front Bumper Fascia Molding Replacement
WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| Preliminary Procedure: Remove front fascia. Refer to Front Bumper Fascia Replacement . |
|
| 1 | Remove Push-pin
WARNING:
Eye protection must be worn when drilling rivets to reduce the chance of personal injury.
|
| 2 | Front Fascia Molding Tip: Disengage integral retainers. |