LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Door Lock System & Door Handles) >> Diagnostic Information and Procedures >> Power Door Lock Key Cylinder Switches Inoperative >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the driver door lock key cylinder switch.
  2. Test for infinite resistance between the signal terminal A and the low reference terminal B with the switch in the Idle position.
    • If not the specified value, replace the driver door lock key cylinder switch.
  3. Test for less than 2 ohms between the signal terminal A and the low reference terminal B with the switch in the unlock position.
    • If greater than the specified range, replace the driver door lock key cylinder switch.
scientia non olet · About LEMON Manuals