LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Door Lock System & Door Handles) >> Diagnostic Information and Procedures >> DTC B3265 >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Relay Test

  1. Ignition OFF, disconnect the TRK REL relay.
  2. Test for 60-180 ohms between terminals 85 and 86.
    • If not within the specified range, replace the relay.
  3. Test for infinite resistance between the following terminals:
    • 30 and 86
    • 30 and 87
    • 30 and 85
    • 85 and 87
    • If not the specified value, replace the relay.
  4. Install a 25A fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for less than 2 ohms between terminals 30 and 87.
    • If greater than the specified range, replace the relay.
scientia non olet · About LEMON Manuals