LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Open Assist Rod Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Upper Hood Assist Rod Ball Stud
    GM105286Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the upper hood assist rod ball stud (2) to the hood (1).

    Tighten:  Tighten the upper hood assist rod ball stud (2) to 9 N.m (80 lb in).

  2. Press the hood assist rod onto the upper hood assist rod ball stud (2).
  3. Ensure that the clip is fully seated on the hood assist rod.
    4. Fig 2: View Of Lower Hood Assist Rod Ball Stud & Fender
    GM130509Courtesy of GENERAL MOTORS CORP.
  4. Install the lower hood assist rod ball stud (1) to the fender (2).

    Tighten:  Tighten the lower hood assist rod ball stud (1) to 24 N.m (18 lb ft).

  5. Press the hood assist rod onto the lower hood assist rod ball stud (1).
  6. Ensure that the clip is fully seated on the hood assist rod.
  7. Close the hood.
scientia non olet · About LEMON Manuals