LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Wiring Systems And Power Management - Service, Troubleshooting & Diagnosis) >> Repairing Connector Terminals >> Tools Required >> Repair Procedure

Repair Procedure

WARNING: This page is about a different car, the 2009 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Cut off the terminal between the core and the insulation crimp. Minimize any wire loss.

    For cable seal terminals, remove the seal.

  2. Apply the correct cable seal per gage size of the wire, if used.

    Slide the seal back along the wire in order to enable insulation removal.

  3. Remove the insulation.
  4. For sealed terminals only, align the seal with the end of the cable insulation.
  5. Position the strip in the terminal.

    For sealed terminals, position the strip and seal in the terminal.

  6. Hand crimp the core wings.
  7. Hand crimp the insulation wings.

    For sealed terminals, hand crimp the insulation wings around the seal and the cable.

  8. Solder all of the hand crimp terminals excepting Micro-Pack 100 .64 size. Soldering Micro-Pack 100 World terminals may damage the terminal.
scientia non olet · About LEMON Manuals