Vehicle Speed Sensor and Transmission Fluid Cooler Pipe Fitting Installation
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the output speed sensor (130) for damage or a cut seal (4).
- Inspect the cooler connector (3) for damaged threads, clogging, or a cut seal (4).
- Install the output speed sensor (130) and the seal (4).
- Install the output speed sensor bolt (131) and tighten to 8-14 N.m (6-10 lb ft).
- Install the cooler fitting (3) and the new seal (4) or fitting (38) and seal (39) into the case.
- Tighten the cooler fitting to 25-29 N.m (19-21 lb ft).
CAUTION:
Refer to Fastener Caution .