Turbine Shaft Seal Replacement - Shaft to Case Cover

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 7079-2 Universal Driver Handle-Non Threaded
J 8092 Driver Handle
J 39062 Turbine Shaft Seal Tool
J 39648 Drive Sprocket Seal Installer

For equivalent regional tools, refer to Special Tools .

Fig 1: Turbine Shaft Seal, Universal Driver Handle-Non Threaded & Turbine Shaft Seal Tool

Courtesy of GENERAL MOTORS COMPANY

Using J 7079-2 universal driver handle-non threaded (1) and the remover side of the J 39062 Turbine Shaft Seal Tool (2), remove the case cover to turbine shaft seal (35).

Fig 2: Drive Sprocket Seal Case Cover

Courtesy of GENERAL MOTORS COMPANY

Using a small screwdriver, remove the case cover to drive sprocket seal (34) by tapping the seal out through the slots in the case cover.

Fig 3: Turbine Shaft Seal Case Cover

Courtesy of GENERAL MOTORS COMPANY

Using J 7079-2 universal driver handle-non threaded (1) the installer side of the J 39062 Turbine Shaft Seal Tool (2), install the case cover to turbine shaft seal (35).

Fig 4: Drive Sprocket Seal, Driver Handle & Seal Installer

Courtesy of GENERAL MOTORS COMPANY

Using J 8092 Driver Handle (1) and J 39648 seal installer (2), install the case cover to drive sprocket seal (34).