Scavenge Pipe Installation
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the scavenge tube (54) for damage and clogging.
- Install the scavenge tube seal (53) into the case.
- Install the scavenge tube (54) into the scavenge tube seals (53) located in the case and in the driven sprocket support. Tap the scavenge tube (54) lightly with a plastic hammer to ensure a tight fit in both seals.
- Install the scavenge tube bolt (15) and tighten to 8-14 N.m (6-10 lb ft).
CAUTION:
Refer to Fastener Caution .