Reverse Clutch Housing Installation

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 34741-3 Input Shaft Seal Sizer

For equivalent regional tools, refer to Special Tools .

Fig 1: Input Shaft Seal Sizer

Courtesy of GENERAL MOTORS COMPANY

Remove the J 34741-3 Input Shaft Seal Sizer.

Fig 2: Installing Reverse Clutch Housing & Second Sprag Assembly

Courtesy of GENERAL MOTORS COMPANY

Install the reverse clutch housing and the second sprag assembly (500-520) onto the reaction carrier assembly (604). The teeth on the reverse clutch housing must seat into the reaction sun shell. Twist the reverse housing to install and insure proper seating.
Install the thrust washer (436) on top of the reverse clutch housing with the tabs pointing down.