Low/Reverse Band and Fretting Ring Installation

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Low Reverse Band

Courtesy of GENERAL MOTORS COMPANY

NOTE:

It may be easier to install the low reverse band if it is installed on the anchor pin first.

Install the low reverse band (13) into the case. Be sure to properly anchor the band in the case with the servo pin stop at the case bore.

Fig 2: View Of Fretting Ring

Courtesy of GENERAL MOTORS COMPANY

Install the fretting ring (835) into the case. Keep the gap in the fretting ring toward the bottom pan with the recessed area next to the anchor pin.