Forward Clutch Support Stud Installation
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Rotate the forward and coast clutch support (822) counterclockwise against the spline. Do this by tapping on the support in a counterclockwise direction against the splines.
- Install the forward clutch support studs (5). First tighten the stud closest to the bench (or the rear of the vehicle) to 25-27 N.m (19-20 lb ft). Then tighten the second stud to 25-27 N.m (19-20 lb ft).
CAUTION:
Refer to Fastener Caution .