Axle Seals Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 39051-1 Right Seal Driver
J 39051-2 Left Seal Driver

For equivalent regional tools, refer to Special Tools .

Fig 1: Prying Out Right And Left Axle Seals

Courtesy of GENERAL MOTORS COMPANY

Using a screw driver remove the right and left axle seals (37, 125) by prying them out.

Fig 2: Axle Seals & Seal Drivers

Courtesy of GENERAL MOTORS COMPANY

Using the J 39051-1 right seal driver and the J 39051-2 left seal driver, install the new axle seals (37, 125). Use the output shaft (57) to pilot the seals and the tool into the case. Ensure that the snap rings are installed on the output shaft.