4th Band Installation

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 34741-3 Input Shaft Seal Sizer

For equivalent regional tools, refer to Special Tools .

Fig 1: Fourth Band

Courtesy of GENERAL MOTORS COMPANY

Install the fourth band (523) into the case. Seat the band properly onto the anchor pin with the seat of the servo pin toward the servo bore in the case.

Fig 2: Seal Sizer & Input Shaft Oil Seal Rings

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Leave the J 34741-3 seal sizer in place until the reverse clutch and housing assembly is ready to be installed.

Install the J 34741-3 seal sizer over the input shaft oil seal rings. Use a twisting motion to install the J 34741-3 seal sizer. The J 34741-3 seal sizer must contact the third clutch housing hub.