Ignition Coil Module Installation - Right Side

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Spark Plug

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the right spark plugs and tighten to 15 N.m (11 lb ft).

Fig 2: Identifying Spark Plug Boots

Courtesy of GENERAL MOTORS COMPANY

Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984) to each spark plug boot (1) of the ignition coil assembly.

Fig 3: Identifying Ignition Coil Assembly Bolts & Ball Studs

Courtesy of GENERAL MOTORS COMPANY

Install the ignition coil assembly.
Install the ignition coil assembly bolts (708) and ball studs (709). Tighten the ignition coil assembly bolts (708) and ball studs (709) to 10 N.m (89 lb in).

Fig 4: Identifying Ignition Coil Assembly Sight Shield Cover

Courtesy of GENERAL MOTORS COMPANY

Install the ignition coil assembly sight shield cover.

Fig 5: Identifying Fuel Injector Sight Shield Bracket

Courtesy of GENERAL MOTORS COMPANY

If equipped, install the fuel injector sight shield bracket.
Install the fuel injector sight shield bracket bolts and tighten to 10 N.m (89 lb in).