Ignition Coil Module Installation - Left Side

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Spark Plug

Courtesy of GENERAL MOTORS COMPANY

CAUTION:

Refer to Fastener Caution .

Install the left spark plugs and tighten to 15 N.m (11 lb ft).

Fig 2: Identifying Spark Plug Boots

Courtesy of GENERAL MOTORS COMPANY

Apply a small amount of dielectric grease GM P/N 12345579, (Canadian P/N 1974984) to each spark plug boot (1) of the ignition coil assembly.

Fig 3: Identifying Ignition Coil Assembly

Courtesy of GENERAL MOTORS COMPANY

Install the ignition coil assembly.
Install the ignition coil assembly bolts and tighten to 10 N.m (89 lb in).