LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 164 (Engine Mechanical - 4.6L - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Engine Block Cleaning and Inspection - Upper >> Cylinder Bore Diameter Measurement Procedure

Cylinder Bore Diameter Measurement Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Measuring Cylinder Bore Diameter
    GM287937Courtesy of GENERAL MOTORS COMPANY
  1. Measure the cylinder bore diameter at 41 mm (1.61 in) below the cylinder block deck surface using the J 8087 .
  2. Compare your results with the engine mechanical specifications. If the cylinder diameter exceeds the specifications, the cylinder block must be replaced. There are no oversized pistons available for service.
scientia non olet · About LEMON Manuals