Crankshaft Balancer Removal

Tools Required

• J 38416-2 Crankshaft Button
• J 41816 Crankshaft Balancer Remover
• J 44214 Flywheel Holder

Fig 1: Flywheel Holder
Courtesy of GENERAL MOTORS COMPANY
1. Install the J 44214 to the engine block.
2. Secure the flywheel in order to prevent crankshaft rotation.
Fig 2: View of Crankshaft Balancer Bolt Threads
Courtesy of GENERAL MOTORS COMPANY
3. Remove the crankshaft balancer bolt.
Fig 3: Crankshaft Balancer Remover
Courtesy of GENERAL MOTORS COMPANY
4. Place the J 38416-2 in the end of the crankshaft.
5. Position the legs of the J 41816 onto the backside of the balancer inner hub.
6. Tighten the center screw on the puller until the balancer pulls clear of the crankshaft end.
Fig 4: View of Crankshaft Balancer
Courtesy of GENERAL MOTORS COMPANY
7. Remove the crankshaft balancer.