Camshaft Cover Installation - Right Side

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 44212 Camshaft Holding Tool

For equivalent regional tools, refer to Special Tools .

Fig 1: Using Camshaft Holding Tool

Courtesy of GENERAL MOTORS COMPANY

Remove the J 44212 tool from the right cylinder head camshafts.

Fig 2: View Of Camshaft Cover & Bolts

Courtesy of GENERAL MOTORS COMPANY

Ensure new camshaft cover seals are installed.
Place the right camshaft cover in position on the cylinder head by aligning the bolt holes.
Install the NEW camshaft cover bolt grommets prior to installing the camshaft cover bolts.

CAUTION:

Refer to Fastener Caution .

Install the camshaft cover bolts and tighten to 10 N.m (89 lb in).

Fig 3: Identifying Ignition Coil Ground Strap & Bolt

Courtesy of GENERAL MOTORS COMPANY

Install the right ignition coil ground strap to the right cylinder head and right camshaft cover.
Install the right cylinder head ignition coil ground strap bolt. Tighten the right cylinder head ignition coil ground strap bolt to 25 N.m (18 lb ft).
Install the right camshaft cover ignition coil ground strap bolt. Tighten the right camshaft cover ignition coil ground strap bolt to 10 N.m (89 lb in).