LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 159 (Power Outlets) >> Repair Instructions >> Cigar Lighter Receptacle or 12-Volt Accessory Power Receptacle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Cigar Lighter Socket/Accessory Power Outlet
    GM1235275Courtesy of GENERAL MOTORS COMPANY
  1. Remove the auxiliary power outlet fuse from the fuse block.
  2. Remove the receptacle:
    1. Look into the receptacle. There are two 3 mm (0.11 in) tab windows 12 mm (0.47 in) from the front of the receptacle. The J 42059  pushes the plastic latches from these tab windows and the receptacle can be pulled straight out.
    2. Place one side of the "T" portion of the J 42059  into the tab window. The J 42059  will not fit straight into the receptacle. Angle the J 42059  slightly for insertion into the receptacle.
    3. Insert the other side of the "T" into the opposite tab window.

      You must move the J 42059  handle toward horizontal to engage the other tab window.

    4. Use the J 42059  to pull the receptacle straight out.
    3. Fig 2: Cigar Housing & Grinding Tool
    GM1120988Courtesy of GENERAL MOTORS COMPANY
  3. If J 42059  tool fails to release the lighter socket from the retainer, perform the following alternate method:
    1. Insert a small grinding tool with a cutoff wheel into the socket.
    2. Remove the plastic latches in the 3 mm (0.11 in) square windows.
    3. Use the J 42059  as directed above to remove the socket.
scientia non olet · About LEMON Manuals