LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 157 (Engine Controls And Fuel - 4.6L - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P2120, P2122, P2123, P2125, P2127, P2128, or P2138 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, observe the DTC information with a scan tool. Verify that DTC P0641 or P0651 are not set.
  2. Observe the scan tool APP Sensor 1 and 2 voltage parameters. Verify both of the APP sensor voltages are between 0.13-4.87 V.
  3. Rapidly depress the accelerator pedal from the rest position to the wide open throttle position (WOT) and release pedal. Repeat the procedure several times. DTCs P2120, P2122, P2123, P2125, P2127, P2128, or P2138 should not set.
  4. Slowly depress the accelerator pedal to WOT and then slowly return the pedal to closed throttle. Repeat the procedure several times. DTCs P2120, P2122, P2123, P2125, P2127, P2128, or P2138 should not set.
  5. Observe the scan tool APP sensor 1 and 2 parameter. The scan tool should display Agree.
  6. Clear the DTCs with the scan tool. Operate the vehicle within the Conditions for Running the DTC or within the conditions that you observed from the Freeze Frame/Failure Records.
  7. Ignition ON, observe the DTC information with a scan tool. Verify that DTC P2120 or P2125 are not the only APP sensor DTCs set.
    • If DTCs P2120 or P2125 are the only DTCs set, replace the ECM.
  8. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals