Conditions for Running the DTC
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0201-P0208, P0300, P0301-P0308, P0401, P0403, P0404, P0405, P0406, P0411, P042E, P0442, P0443, P0446, P0449, P0452, P0453, P0455, P0496, P0506, P0507, P2440, P2444 are not set.
- The engine is in Closed Loop status.
- The Catalyst Monitor Intrusive Test, Post O2 Diagnosis Intrusive Test, EGR Flow Diagnosis Intrusive Test, Device Control, and EVAP Diagnosis "tank pull down" are Not Active.
- The engine coolant temperature (ECT) is between -38 and +130°C (-36 and +266°F).
- The intake air temperature (IAT) is between -20 and +150°C (-4 and +302°F).
- The manifold absolute pressure (MAP) is between 15-256 kPa (2.2-37.1 psi).
- The engine speed is between 400-6,350 RPM.
- The mass air flow (MAF) is between 1-512 g/s.
- The barometric pressure (BARO) is greater than 70 kPa (10.2 psi).
- The fuel level is greater than 10 percent.
- This diagnostic runs continuously when the above conditions have been met.