LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Suspension Control System - Suspension Leveling - ASCM) >> Repair Instructions >> Air Spring Replacement

Air Spring Replacement

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Air Spring
GM1671473Courtesy of GENERAL MOTORS COMPANY
Air Spring Replacement

Callout Component Name

Preliminary Procedures

  1. Depressurize the air suspension. Refer to Air Suspension Depressurization .
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  4. Remove the rear leveling sensor link from the control arm. Refer to Air Spring Leveling Sensor Replacement .
  5. Place a suitable support under the control arm.
  6. Pressurize the air suspension system after the repair has been completed. Refer to Air Suspension Pressurization .
1 Rear Adjusting Link Nut
CAUTION:

Refer to Fastener Caution .


Tighten 
30 N.m (22 lb ft) plus an additional 180°.
2 Rear Adjusting Link
TIP:  Use the J 24319-B to remove the adjusting link from the control arm.
Special Tools 
J 24319-B Steering Linkage Puller
3 Rear Shock Bolt (Qty: 2)
Tighten 
25 N.m (18 lb ft)
4 Rear Suspension Air Spring
  1. Disconnect the air supply line at the air spring.
  2. Lower the control arm to remove the air spring.