LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Automatic Transmission - 4T80-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Vehicle Speed Sensor & Retaining Bolt
    GM11835Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the vehicle speed sensor (130) and the retaining bolt (131). Install a new O-ring seal on sensor if necessary.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

  2. Install the electrical connector at the sensor.
    3. Fig 2: Mounting Bolt Locations For Front Transaxle Brace
    GM588753Courtesy of GENERAL MOTORS COMPANY
  3. Install the bolts (1, 3) securing the front transaxle brace (2) to the transaxle and right cylinder head.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals