LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Automatic Transmission - 4T80-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Transmission Brace Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine to transaxle brace.
    2. Fig 1: View of Transaxle Brace & Fasteners
    GM627408Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the fasteners into the engine and transmission.

    Tighten 

    Tighten the brace bolts to 50 N.m (37 lb ft).

    3. Fig 2: View of Heat Shield
    GM627402Courtesy of GENERAL MOTORS COMPANY
  3. Install the heat shield.
  4. Install the heat shield fasteners.

    Tighten 

    Tighten the heat shield nuts to 50 N.m (37 lb ft).

  5. Install the right front tire. Refer to Tire and Wheel Removal and Installation .
scientia non olet · About LEMON Manuals