LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Automatic Transmission - 4T80-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Output Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Output Shaft & Snap Rings
    GM15507Courtesy of GENERAL MOTORS COMPANY
  1. Inspect the output shaft (57) splines for burrs or damage. Inspect the snap rings (56) for overexpansion.
    2. Fig 2: View Of Snap Rings & Output Shaft
    GM15510Courtesy of GENERAL MOTORS COMPANY
  2. Install the snap rings (56) onto the output shaft and install the output shaft (57) from the channel plate side of the transmission.
  3. Install the differential carrier. Refer to Differential Carrier Replacement .
  4. Install the left drive axle. Refer to Wheel Drive Shaft Replacement (FE7) , Wheel Drive Shaft Replacement (FE1, FE3) .
scientia non olet · About LEMON Manuals