LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Power Steering System) >> Repair Instructions >> Power Steering Pump Pulley Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Pump Pulley Installer
    GM643361Courtesy of GENERAL MOTORS COMPANY
  1. Using J 25033-C  install the power steering pulley to the power steering pump.
    2. Fig 2: Measuring Axial Tolerance Of Power Steering Pulley On Pump
    GM254752Courtesy of GENERAL MOTORS COMPANY
  2. Ensure that the axial tolerance of the power steering pulley on the power steering pump is within 0.25 mm (0.010 in), plus or minus.
  3. Install the drive belt. Refer to Drive Belt Replacement .
    4. Fig 3: View Of Surge Tank, Nuts & Screw
    GM517960Courtesy of GENERAL MOTORS COMPANY
  4. Install the surge tank (1) to the vehicle.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the surge tank retaining bolt (3) and nut (2).

    Tighten 

    Tighten the surge tank retaining bolt (3) and nut (2) to 6 N.m (53 lb in).

    6. Fig 4: View Of Secondary AIR Relay Bracket & Nuts
    GM518257Courtesy of GENERAL MOTORS COMPANY
  6. Install the secondary AIR relay bracket to the mounting studs.
  7. Install the secondary AIR relay bracket retaining nuts.

    Tighten 

    Tighten the secondary AIR relay bracket retaining nuts (2) to 6 N.m (53 lb in).

scientia non olet · About LEMON Manuals