Installation Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the brake pedal assembly to the vehicle.
- Install the brake pedal assembly nuts (1).
- For vacuum brake booster equipped vehicles, tighten the nuts to 30 N.m (22 lb ft).
- For hydraulic brake booster equipped vehicles, tighten the nuts to 36 N.m (27 lb ft)
- Connect the brake pedal pushrod to the brake pedal.
- Install the brake pedal pushrod retaining clip (1).
Rotate the brake pedal pushrod retaining clip to ensure the clip is fully engaged to the groove in the brake pedal clevis pin.
- Install the brake pedal pushrod retaining clip verification bolt (1) and tighten to 7 N.m (62 lb in).
- Install the accelerator pedal position sensor. Refer to Accelerator Pedal Position Sensor Replacement .
- Install the brake pedal position sensor. Refer to Brake Pedal Position Sensor Replacement .
- Install the steering column assembly. Refer to Steering Column Replacement .
CAUTION:
Refer to Fastener Caution .