Rear Seat Lumbar Control Switch Replacement
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
Rear Seat Lumbar Control Switch Replacement
| Callout | Component Name |
|---|---|
| Preliminary Procedure Remove the rear side door trim panel. Refer to Rear Side Door Trim Panel Replacement . |
|
| 1 | Rear Side Door Trim Assembly |
| 2 | Rear Seat Lumbar Control Switch Screw (Qty: 3)
CAUTION:
Refer to Fastener Caution . Tighten 2 N.m (18 lb in) |
| 3 | Rear Seat Lumbar Control Switch TIP: Disconnect the electrical connector. |