LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 134 (Seat Heating System And Seat Cooling System) >> Diagnostic Information and Procedures >> DTC B19A2, B19A6, B111D, or B272F >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the seat back and seat cushion ventilation heat and cool modules.
  2. Ignition OFF and all vehicle systems OFF with the scan tool disconnected, it may take up to 2 minutes for all vehicle systems to power down.
  3. Test for less than 5 Ω between the seat back blower low reference circuit terminal 4 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the CCSM.
  4. Connect a test lamp between the seat back blower control circuit terminal 2 and ground.
  5. Ignition ON, command the Passenger Seat Blower Cmd. ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the CCSM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open high resistance. If the circuit tests normal, replace the CCSM.
    6. NOTE:

    This step requires using a GM approved test lamp, failure to do so may result in a miss-diagnosis of the module.

  6. Connect a test lamp between the seat back blower control circuit terminal 7 and ground.
  7. Ignition ON, command the Passenger Seat Blower Cmd. ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the CCSM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the CCSM.
  8. Connect the harness connector at the seat back ventilation heat and cool module.
  9. Ignition ON, command the Passenger Seat Blower Cmd. ON and OFF with a scan tool. The seat back blower should turn ON an OFF when changing between the commanded states.
    • If the blower is always OFF, test or replace the seat back ventilation heat and cool module.
  10. Ignition OFF, connect the harness connector at the seat cushion ventilation heat and cool module.
  11. Ignition ON, command the Passenger Seat Blower Cmd. ON and OFF with a scan tool. The seat cushion blower should turn ON an OFF when changing between the commanded states.
    • If the blower is always OFF, test or replace the seat cushion ventilation heat and cool module.
  12. If all circuits test normal, replace the CCSM.
scientia non olet · About LEMON Manuals