Rear Brake Caliper Hardware Replacement (J55)

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Disc Brake Hardware - (J55)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Fastener Tightening Specifications: Refer to Fastener Tightening Specifications . Preliminary Procedure Remove the brake caliper mounting bracket. Refer to Rear Brake Caliper Hardware Replacement (JL9) , Rear Brake Caliper Hardware Replacement (J55) .
1	Guide Pin
2	Guide Pin Boot Install the bracket in a vise. Insert a flat-bladed screwdriver between the boot and the bracket. Using a flat-bladed screwdriver, remove the boot.
3	Guide Pin Bushing Using a small flat-bladed screwdriver, carefully insert the screwdriver into the mounting bore for the bushing. Rotate and pull the bushing outward to remove the bushing. Use denature alcohol to clean the mounting bracket.