Installation Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the shock on the vehicle.
- Install the shock upper mount.
- Install the shock reinforcement and the two nuts.
Tighten
Tighten the nuts to 25 N.m (18 lb ft).
- Install the shock cover.
- Position the trunk trim in the proper location.
- Install the lower shock bolts.
Tighten
Tighten the bolts to 25 N.m (18 lb ft).
- Connect the electronic air control air tube to the shock.
- Connect the electrical connector and route the wiring on the control arm (FE3 and FE45).
- Install the wheel and the tire. Refer to Tire and Wheel Removal and Installation
.
Tighten
Tighten the wheel nuts to 125 N.m (80 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution .
NOTE:
Before lowering the vehicle onto its wheels (or before driving the vehicle, if it was not on a lift) turn the ignition ON and wait approximately 45 seconds. This will permit the ALC system to execute the ARC, ensuring that the air adjustable shock absorbers are filled with residual pressure.