Installation Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the control arm to the rear suspension support assembly.
- Install the hub and bearing, if necessary. Refer to Rear Wheel Bearing and Hub Replacement (FE1, FE3) , Rear Wheel Bearing and Hub Replacement (FE7) .
- Install a new stabilizer link bolt and nut.
Tighten
Tighten the new stabilizer link bolt nut to 15 N.m (11 lb ft).
- Install the rear suspension support assembly. Refer to Rear Support Replacement (w/FE1, FE3) , Rear Support Replacement (w/FE7) .
- Install the support bracket bolts (1).
- Lower the vehicle to obtain trim height.
- Tighten the control arm nuts.
Tighten
Tighten the control arm nuts to 149 N.m (110 lb ft).
- Lower the vehicle.
NOTE:
The control arm nuts should be tightened with the vehicle unsupported and resting on the wheels at the normal trim height.
CAUTION:
Refer to Fastener Caution .