LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Rear Suspension System) >> Repair Instructions >> Coil Spring Replacement (FE7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Control Arm, Air Tube, Shock & Bolts
    GM567535Courtesy of GENERAL MOTORS COMPANY
  1. Raise the vehicle and support. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tires and the wheels. Refer to Tire and Wheel Removal and Installation .
  3. Support the control arm with a suitable jack.
  4. Remove the electronic level control air tube from the shock.
  5. Remove the 2 bolts securing the shock to the control arm.
    6. Fig 2: Steering Linkage Puller & Outer Tie Rod Assembly
    GM643351Courtesy of GENERAL MOTORS COMPANY
  6. Remove the hex nut.
  7. Using the J 24319-B 
    8. Fig 3: Coil Spring & Compressor
    GM629633Courtesy of GENERAL MOTORS COMPANY
  8. Install the J 44255 .
  9. Slowly lower the control arm until it bottoms on the support assembly.
  10. Remove the coil spring.
scientia non olet · About LEMON Manuals