Removal Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refer to Exhaust Service Warning .
WARNING:
Refer to Protective Goggles and Glove Warning .
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Drill out the rivets.
- Lower the heat shield until the heated oxygen sensor (HO2S) clips can be disconnected.
- Disconnect the HO2S clips from the heat shield.
- Remove the heat shield.
WARNING:
Eye protection must be worn when drilling rivets to reduce the chance of personal injury.