LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 125 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Heat Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Catalytic Converter Heat Shield
    GM1670478Courtesy of GENERAL MOTORS COMPANY
  1. Position the heat shield to the floor panel.
  2. Using a rivet gun, install the rivets (2), except for this location (1), this rivet will be installed with the oxygen sensor heat shield.
  3. Install the exhaust system. Refer to Exhaust System Replacement .
scientia non olet · About LEMON Manuals