LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Engine Controls And Fuel - 4.6L - Repair Instructions) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Knock Sensor
    GM1672563Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the appropriate knock sensor.

    Tighten 

    Tighten the sensor to 25 N.m (18 lb ft).

    2. Fig 2: Identifying CKP Sensor Wiring Harness Electrical Connector
    GM1672558Courtesy of GENERAL MOTORS COMPANY
  2. Connect the electrical connector (2) to the left knock sensor, if required.
    3. Fig 3: Identifying Electrical Connector
    GM1672557Courtesy of GENERAL MOTORS COMPANY
  3. Connect the electrical connector (3) to the right knock sensor, if required.
  4. Install the intake manifold. Refer to Intake Manifold Replacement .
scientia non olet · About LEMON Manuals