Removal Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The exhaust gas recirculation (EGR) valve inlet pipe incorporates a crush seal connection at the water pump housing. The EGR valve inlet pipe must be replaced if disconnected from the water pump housing.
- Remove the EGR pipe bolt at the water pump housing.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Loosen the EGR pipe nut at the exhaust manifold.
- Remove the EGR valve pipe.