Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying EVAP Canister Vent Solenoid Valve

Courtesy of GENERAL MOTORS COMPANY

Install the EVAP canister vent solenoid valve to the new canister.

Fig 2: Identifying EVAP Canister

Courtesy of GENERAL MOTORS COMPANY

Rotate the EVAP canister vent solenoid valve clockwise until the solenoid valve comes to a stop in the retainer.

Fig 3: View Of EVAP Canister

Courtesy of GENERAL MOTORS COMPANY

Place the EVAP canister near the underbody.
Connect the rear body harness electrical connector to the EVAP canister vent solenoid.

Fig 4: Locating EVAP Canister

Courtesy of GENERAL MOTORS COMPANY

Install the EVAP canister onto the studs.

CAUTION:

Refer to Fastener Caution .

Install the EVAP canister nuts.
Tighten

Tighten the nuts to 6 N.m (53 lb in).

Fig 5: Identifying Fuel Fill Pipe Vent Line & Fuel Tank Vapor Line Quick Connect Fitting

Courtesy of GENERAL MOTORS COMPANY

Connect the fuel fill pipe vent line quick connect fitting (2) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
Connect the fuel tank vapor line quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
Connect the chassis EVAP pipe quick connect fitting (1) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
Lower the vehicle. Refer to Lifting and Jacking the Vehicle .