LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Engine Controls And Fuel - 4.6L - Repair Instructions) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating CKP Sensor Wiring Harness Electrical Connector
    GM1672560Courtesy of GENERAL MOTORS COMPANY
  1. Lubricate the crankshaft sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the CKP sensor bolt.

    Tighten 

    Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying CKP Sensor Wiring Harness Electrical Connector
    GM1672558Courtesy of GENERAL MOTORS COMPANY
  4. Connect the CKP sensor wiring harness electrical connector (1) to the CKP sensor.
  5. Install the intake manifold. Refer to Intake Manifold Replacement .
  6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About LEMON Manuals