LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 123 (Engine Controls And Fuel - 4.6L - Repair Instructions) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CMP Sensor Wiring Harness Connector
    GM1672927Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the electrical connector (1) from the camshaft position (CMP) sensor.
    2. Fig 2: Identifying CMP Sensor
    GM1672561Courtesy of GENERAL MOTORS COMPANY
  2. Remove the CMP sensor bolt.
  3. Remove the CMP sensor.
scientia non olet · About LEMON Manuals