Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Ring & Wheel Speed Sensor Reluctor

Courtesy of GENERAL MOTORS COMPANY

Thoroughly clean any locking compound residue and debris from the inner surface of the wheel speed sensor reluctor ring with denatured alcohol or equivalent and allow to dry.
Apply Loctite® GM P/N 12345493 (Canadian P/N 10953488) or equivalent to the inner portion of the wheel speed sensor reluctor (2).
Insert the wheel speed sensor reluctor (2) onto the hub assembly.
Install the ring (1) of the J 44253 onto the wheel speed sensor reluctor.

Fig 2: ABS Reluctor Installer

Courtesy of GENERAL MOTORS COMPANY

Insert the J 44253 (1).

NOTE:

Turn the J 44253 until it just touches the ring of the J 44253 .

Turn the J 44253 (1) to thread the wheel speed sensor reluctor.
Install the wheel speed sensor. Refer to Rear Wheel Bearing and Hub Replacement (FE1, FE3) , Rear Wheel Bearing and Hub Replacement (FE7) .