LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 121 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement (FE7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Stabilizer Link Insulators, Washers, Nut, & Bolt
    GM474719Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the stabilizer link insulators, washers, spacer, nut and bolt.

    Tighten 

    Tighten the stabilizer link nut to 23 N.m (17 lb ft).

  2. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals