LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Secondary Timing Chain Tensioner Shoe Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Right Secondary Camshaft Drive Chain Shoe
    GM685343Courtesy of GENERAL MOTORS COMPANY
  1. Position the right secondary camshaft drive chain shoe in through the front cover area.
    2. Fig 2: Identifying Right Secondary Camshaft Drive Chain Shoe Bolt
    GM685338Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the right secondary camshaft drive chain shoe bolt.

    Tighten 

    Tighten the secondary camshaft drive chain shoe bolt to 25 N.m (18 lb ft).

    3. Fig 3: Locating Camshaft Drive Chain Shoe Access Plugs On Front Of Engine
    GM748194Courtesy of GENERAL MOTORS COMPANY
  3. Install the right secondary camshaft drive chain shoe access plug (1) located in the cylinder head. Ensure the O-ring seal is attached to the access plug.

    Tighten 

    Tighten the secondary camshaft drive chain shoe access plug to 4.5 N.m (40 lb in).

  4. Install the right secondary camshaft drive chain tensioner. Refer to Secondary Camshaft Intermediate Drive Chain Tensioner Replacement - Right Side .
    5. Fig 4: Using Camshaft Holding Tool
    GM650538Courtesy of GENERAL MOTORS COMPANY
  5. Remove the J 44212 from the camshafts.
  6. Install the right camshaft cover. Refer to Camshaft Cover Replacement - Right Side .
scientia non olet · About LEMON Manuals