LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Oil Pump Outlet Tube Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Outlet Tube O-Ring
    GM928363Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW O-ring on the oil outlet tube.
    2. Fig 2: View Of Oil Outlet Tube Bolts
    GM928361Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the oil outlet tube and bolts.

    Tighten 

    Tighten the oil outlet tube bolts to 10 N.m (89 lb in).

    3. Fig 3: Identifying Primary Timing Gear Alignment Marks
    GM517185Courtesy of GENERAL MOTORS COMPANY
  3. Ensure the primary timing marks (1) are aligned vertically.
  4. Install the primary drive chain tensioner. Refer to Primary Camshaft Intermediate Drive Chain Tensioner Replacement .
  5. Install the secondary camshaft drive chains. Refer to Secondary Camshaft Intermediate Drive Chain Replacement - Left Side , and Secondary Camshaft Intermediate Drive Chain Replacement - Right Side .
  6. Install the oil pump. Refer to Oil Pump Replacement .
scientia non olet · About LEMON Manuals