LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Support Fixture >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Lift Hook
    GM1660451Courtesy of GENERAL MOTORS COMPANY
  1. Remove the J 28467-7A lift hook from the engine mount strut bracket.
  2. Remove the J 28467-B .
  3. Remove the J 28467-501 .
    4. Fig 2: Identifying Engine Mount Strut Bolt
    GM1660428Courtesy of GENERAL MOTORS COMPANY
  4. Install the engine mount strut.
    5. CAUTION:

    Refer to Fastener Caution .

  5. Install the engine mount strut bolt.

    Tighten 

    Tighten the bolt to 70 N.m (52 lb ft).

    6. Fig 3: View Of Engine Mount Strut Brace Bolt & Nut
    GM1660425Courtesy of GENERAL MOTORS COMPANY
  6. Install the engine mount strut brace.
  7. Install the engine mount strut brace bolt and nut.

    Tighten 

    • Tighten the bolt to 50 N.m (37 lb ft).
    • Tighten the nut to 70 N.m (52 lb ft).
    8. Fig 4: Identifying Surge Tank
    GM1660422Courtesy of GENERAL MOTORS COMPANY
  8. Position the surge tank to the studs.
  9. Install the surge tank nuts and push pin retainer.

    Tighten 

    Tighten the nuts to 6 N.m (53 lb in).

  10. Install the front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  11. Install the air inlet grille. Refer to Air Inlet Grille Panel Replacement .
scientia non olet · About LEMON Manuals