LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> Vibe Base, 2.4 0, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 (Engine Mechanical - 4.6L - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Engine Front Mount Bracket Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Engine Mount Bracket-To-Engine Stud Nuts
    GM1660847Courtesy of GENERAL MOTORS COMPANY
  1. Install the lower engine mount bracket onto the engine studs.
  2. Install the transaxle brace.
  3. Install the lower engine mount bracket to engine stud nuts finger tight.
    4. Fig 2: View Of Transaxle Brace & Bolt
    GM1660864Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  4. Install the transaxle brace bolt.

    Tighten 

    • Tighten the transaxle brace bolt to 50 N.m (37 lb ft).
    • Tighten the lower engine mount bracket to engine stud nuts to 50 N.m (37 lb ft).
    5. Fig 3: Identifying Front Engine Mount Bracket Bolts/Nuts
    GM1660849Courtesy of GENERAL MOTORS COMPANY
  5. Install the upper engine mount bracket onto the studs.
  6. Install the engine mount bracket to cylinder head bolts.

    Tighten 

    Tighten the bolts to 50 N.m (37 lb ft).

  7. Install the upper engine mount bracket to lower engine mount bracket nuts.

    Tighten 

    Tighten the nuts to 50 N.m (37 lb ft).

  8. Install the front frame. Refer to Drivetrain and Front Suspension Frame Replacement (4.6L) .
scientia non olet · About LEMON Manuals